3040-00-001-1295 is not a replacement of any national stock number and has not been cancelled or replaced itself.
DEMIL Code Meaning:
Non-usml/non-ccli - no demil or dod tsc required. department of commerce may impose licensing requirements to certain destinations.
0 (Represents items with no adp components)
Power Trans Shafting/shafts
Motors and parts, (machinery and parts),(less than 35 feet)
No special type of cargo code applicable
Other or no special handling required (sh)
Shipment is not a consolidation and does not exceed 84 inches in any dimension.
Trailers, vehicles, machinery, shop and warehouse equipment and supplies including special tools and equipment, ground servicing
No special handling required.
------- (MOE: DS)
Terminal item # (non-stocked items). future procurement is not authorized. no wholesale stock is available for issue. 1. requisitions will not be processed to the wholesale manager. 2. internal service/agency requisitioning may be continued
Schedule B & Trade:
8483105000 (NAICS 333613) Transmission shafts and cranks, except camshafts and crankshafts
Transmission shafts (including cam and crank shafts) and cranks
End Use: 21180
Industrial machines, other
Questions & Answers:
What are the historical prices recorded for this stock number?
No pre-dated pricing for this NSN could be found.
What NATO entities are users of this NSN?
Morocco, Korea, Republic Of, and Turkey
How is national stock number 3040-00-001-1295 defined?
A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.o25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. it is not designed for use in aligning by fitting into corresponding holes of another item. it may be drilled for lubricating holes. for items having an integral gear(s) or worm(s), see gearshaft (as modified). for items designed to support rotating members see axle(1), straight. for items not having the above conditions see pin, straight, headless. for items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.
Does this item require Demilitarization?
Non-usml/non-ccli - no demil or dod tsc required. department of commerce may impose licensing requirements to certain destinations. (note 9).
Is this item ITAR controlled?
No. This item is not ITAR Controlled.
When was this national stock number assigned to the federal catalog?