Request Pricing & Availability

NSN: 3040-00-001-2341
Part Number(s):
Name & Email:
Order Terms | Privacy Policy    

NSN 3040-00-001-2341 Straight Shaft

Manufacturer Part Numbers

Part Number Name Cage Code
659380 Shaft,straight 05234

Management Codes

CTL: 9B----- (MOE: DN)
AAC: Not stocked, centrally procured # (non-stocked items). imm/service centrally managed but not stocked item. procurement will be initiated only after receipt of a requisition.
SLC: 0

Freight Codes

NMF Desc: Power Trans Shafting/shafts
NMFC: 126900
UFC: 65750
LTL: Rating variable
WCC: Motors and parts, (machinery and parts),(less than 35 feet)
TCC: No special type of cargo code applicable
SHC: Other or no special handling required (sh)
ADC: Shipment is not a consolidation and does not exceed 84 inches in any dimension.
ACC: Trailers, vehicles, machinery, shop and warehouse equipment and supplies including special tools and equipment, ground servicing
ASH: No special handling required.


DEMIL Integ:
ESD: )
Schedule B: 8483105000 – Transmission shafts and cranks, except camshafts and crankshafts
NIIN: 000012341

3040-00-001-2341 Datasheet

End Similarity: Not identical
First End Diameter: 0.2480 inches minimum and 0.2510 inches maximum
First End Style: Plain
Material Document And Classification: Qq-s-763,class 303,cond a fed spec single material response or qq-s-763,class 304,cond a fed spec single material response
Material: Steel
Second End Distance From End To Groove: 0.120 inches nominal
Second End Groove Diameter: 0.1880 inches nominal
Second End Groove Width: 0.0160 inches nominal
Second End Style: Circular grooved
Overall Length: 2.380 inches nominal
Surface Finish: 63.0 microinches

Questions & Answers

What are the historical prices recorded for this stock number?
No pre-dated pricing for this NSN could be found.
What NATO entities are users of this NSN?
Belgium, Italy, Turkey, and United States
How is national stock number 3040-00-001-2341 categorized?
A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.o25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. it is not designed for use in aligning by fitting into corresponding holes of another item. it may be drilled for lubricating holes. for items having an integral gear(s) or worm(s), see gearshaft (as modified). for items designed to support rotating members see axle(1), straight. for items not having the above conditions see pin, straight, headless. for items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.
Does this item require Demilitarization?
Non-usml/non-ccli - no demil or dod tsc required. department of commerce may impose licensing requirements to certain destinations. (note 9).
Is this item ITAR controlled?
No. This item is not ITAR Controlled.
When was this national stock number assigned to the federal catalog?
Sep 24, 1972