Request Pricing & Availability

NSN: 5310-00-001-4648
Part Number(s):
Quantity:
Company:
Name & Email:
Phone:
Order Terms | Privacy Policy    

NSN 5310-00-001-4648 Flat Washer

Manufacturer Part Numbers

Part Number Name Cage Code
A51P60723-15 Washer,flat 61174

Management Codes

CTL: ------- (MOE: DS)
SOS: SMS
AAC: Not stocked, centrally procured # (non-stocked items). imm/service centrally managed but not stocked item. procurement will be initiated only after receipt of a requisition.
CIIC:
RC:
QUP: 1
UI: EA
SLC: 0

Freight Codes

NMF Desc: Washer Or Gaskets, Iron Or Steel,
NMFC: 194160
UFC: 55210
LTL: 50.0
LCL:
WCC: Metal hardware
TCC: No special type of cargo code applicable
SHC: Other or no special handling required (sh)
ADC: Shipment is not a consolidation and does not exceed 84 inches in any dimension.
ACC: Construction materials: includes paint and related materials, prefabricated building, wood products, metal and composition mater
ASH: No special handling required.

Identification

DEMIL Code: A
DEMIL Integ:
ADPE: )
CRITL: X
ENAC:
ESD: )
HMIC: N
Schedule B:
NIIN: 000014648

Technical Characteristics

Center Hole Shape Style: Round
Cross-sectional Shape Style: Rectangular
Hole Diameter: 0.515 inches nominal
Overall Diameter: 0.890 inches minimum and 0.915 inches maximum
Peripheral Shape Style: Round
Test Data Document: 81349-mil-i-6866 specification (includes engineering type bulletins, brochures,etc., that reflect specification type data in specification format; excludes commercial catalogs, industry directories, and similar trade publications, reflecting general type data on certain environmental and performance requirements and test conditions that are shown as "typical", "average", "nominal", etc.).
Thickness: 0.135 inches minimum and 0.140 inches maximum

Questions & Answers

What are the historical prices recorded for this stock number?
No pre-dated pricing for this NSN could be found.
What NATO entities are users of this NSN?
No recorded entities for this stock number.
How is national stock number 5310-00-001-4648 categorized?
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.
Does this item require Demilitarization?
Non-usml/non-ccli - no demil or dod tsc required. department of commerce may impose licensing requirements to certain destinations. (note 9).
Is this item ITAR controlled?
No. This item is not ITAR Controlled.
When was this national stock number assigned to the federal catalog?
Sep 27, 1972