Request Pricing & Availability

NSN: 3040-00-001-6241
Part Number(s):
Quantity:
Company:
Name & Email:
Phone:
Order Terms | Privacy Policy    

Cross Reference These part numbers have the same form, fit, and function of d64311

Item Number Cage
D64311 10988
D30569 10988

Characteristic Codes D64311 spec. code meanings

Code Translation
AAHN A term used to identify the ends as identical or not identical.
AMDL The length of a straight line which passes through the center of the first end, and terminates at the circumference.
AMDM A measurement of the longest dimension of the first end spline, in distinction from width.
AMDP The length of a straight line which passes through the center of the largest circular cross section of the first end spline, and terminates at the circumference.
AMDN The length of a straight line which passes through the center of the smallest circular cross section of the first end spline, and terminates at the circumference.
AAGZ The style designation indicating the configuration that most nearly corresponds to the appearance of the first end.
MATT The chemical compound or mechanical mixture properties of which the item is fabricated.
ABHP The dimension measured along the longitudinal axis with terminated points at the extreme ends of the item.

D64311 Straight Shaft

Mfr. Cage 10988

Specification

steel comp 1035 Length: 3-13/16"

AAHN End Similarity
Identical
AMDL First End Diameter
0.8750 inches
AMDM First End Spline Length
3.812 inches
AMDP First End Spline Major Diameter
0.8750 inches
AMDN First End Spline Minor Diameter
0.8720 inches
BDSQ First End Spline Quantity
13
AAGZ First End Style
Splined (straight)
MATT Material
Steel comp 1035
ABHP Overall Length
3.812 inches

Technical Definition

Shaft, Straight, also referenced with federal logistics item name code 22109 - A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.o25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. it is not designed for use in aligning by fitting into corresponding holes of another item. it may be drilled for lubricating holes. for items having an integral gear(s) or worm(s), see gearshaft (as modified). for items designed to support rotating members see axle(1), straight. for items not having the above conditions see pin, straight, headless. for items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.
National Stock Number (NSN) 3040-00-001-6241

Last Modified: 02/14/2017