NSN MTF100A

An item used on the high pressure side of a refrigerant compressor as a reservoir for the liquid refrigerant and provides a positive seal to prevent the escape of uncondensed gases to the expansion values. Excludes:accumulator, refrigerant.

"14632-mtf100a specification (includes engineering type bulletins, brochures,etc., that reflect specification type data in specification format; excludes commercial catalogs, industry directories, and similar trade publications, reflecting general type data on certain environmental and performance requirements and test conditions that are shown as "typical", "average", "nominal", etc.)." test data document, gne;mtf100a end item identification, tuning frame is designed to mounttwo th series microwave tuning heads and provide the necessary interface connections and power for their operation;with addition of an mtf101 tuning frame this capability is extended to a total of four tuning heads w/power and interface connections provided by the mtf100a;front panel switch permits selection of one of the four tuning heads for operation;all operating voltages are supplied to the switch selected tuning head;mtf100a employs a frequency translator for down converting the 160mhz if output from any of the tuners toan if of 21.4mhz;both 160mhz and 21.4mhz if outputs are available at rear panel connectors on the mtf100a;all signal and power connections are made at the rear panel of the units;front panelcontrols include power,fine tuning,tuner select and afc;19in mounted rack 3.5in vertical 16in deep;50watts approx 4 tuners installed general characteristics item description.

NSN 5985-00-615-2449 Datasheet

(NSN) National Stock Number

5985-00-615-2449

(FSG) Federal Supply Group

59 - Electrical and Electronic Equipment Components

(FSC) Federal Supply Classification

5985 - Related Equipment, Waveguides and Antennas

(NIIN) National Item Identification Number

00-615-2449

Requires Demilitarization

Yes

(INC) Item Name Code

77777

Date

Wed, Feb 12, 1975

Schedule B Code

8529109000

End Item Identification

gne;mtf100a

General Characteristics Item Description

tuning frame is designed to mounttwo th series microwave tuning heads and provide the necessary interface connections and power for their operation;with addition of an mtf101 tuning frame this capability is extended to a total of four tuning heads w/power and interface connections provided by the mtf100a;front panel switch permits selection of one of the four tuning heads for operation;all operating voltages are supplied to the switch selected tuning head;mtf100a employs a frequency translator for down converting the 160mhz if output from any of the tuners toan if of 21.4mhz;both 160mhz and 21.4mhz if outputs are available at rear panel connectors on the mtf100a;all signal and power connections are made at the rear panel of the units;front panelcontrols include power,fine tuning,tuner select and afc;19in mounted rack 3.5in vertical 16in deep;50watts approx 4 tuners installed

Test Data Document

"14632-mtf100a specification (includes engineering type bulletins, brochures,etc., that reflect specification type data in specification format; excludes commercial catalogs, industry directories, and similar trade publications, reflecting general type data on certain environmental and performance requirements and test conditions that are shown as "typical", "average", "nominal", etc.)."

Identification

Demilitarization Code

D - Usml or ccl military items - demil required. Destroy item and components to prevent restoration or repair to a usable condition. (note 5).

Precious Metals Indicator

U - Precious metal content is unknown

Hazardous Metals Indicator

P - Indicates there is no information in the hmirs. The nsn is in a fsc in table ii of fed std 313 and a msds may be required by the user. The requirement for a msds is dependent on a hazard determination of the supplier or the intended end use of item.

Source of Supply Code

FPD - Air force cryptologic support group 230 hall blvd, bldg 2028 san antonio, tx 78243-7081

Pseudo Item Name Code

1361290

Cross Reference

CAGE Codes

14632

Drs Signal Solutions, Inc.

U.s./canadian manufacturers

K6808

Watkins-Johnson International

Non-us manufacturer (nato), other foreign organization or codification bureaus

U6328

Bertin Exensor Limited

Non-us manufacturer (nato), other foreign organization or codification bureaus

Freight Information

Air Commodity

HQ -

Air Dimension

A - Shipment is not a consolidation and does not exceed 84 inches in any dimension.

Less than Carload Rating

P - 77.5

National Motor Freight Class Rating

W - Rating variable

Rail Variation

1

Special Handling

Q - High sensitivity, category ii, aa&e, classified confidential

Type of Cargo

Z - No special type of cargo code applicable

Uniform Freight Classification Item Number

34580

Water Commodity

72D - Communications/electronics, other than sigint/ew or comsec repair parts and components

National Motor Freight Classification Item Number

061700

Schedule B & Trade

Schedule B

8529-10-9000

Description

antenna & antenna reflectors of all kinds; parts suitable for use soley or principally w/ apparatus of heading 8524 to 8528, nesoi

End Use

21400 - Telecommunications equipment

Unit of Quantity

NO

USDA

Yes

(SITC) Standard International Trade Classification

76493

(NAICS) North American Industrial Classification System

334220

Questions & Answers

1. What is the FSCG of the NSN 5985-00-615-2449?

   The FSCG of the NSN 5985-00-615-2449 is 5985

2. Does the NSN 5985-00-615-2449 have a Schedule B code assigned?

   Yes, the Schedule B code is 8529109000

3. Does NSN 5985-00-615-2449 require demilitarization?

   Usml or ccl military items - demil required. Destroy item and components to prevent restoration or repair to a usable condition. (note 5).

4. Does NSN 5985-00-615-2449 contain precious materials?

   Precious metal content is unknown

5. Does NSN 5985-00-615-2449 contain hazardous materials?

   Indicates there is no information in the hmirs. The nsn is in a fsc in table ii of fed std 313 and a msds may be required by the user. The requirement for a msds is dependent on a hazard determination of the supplier or the intended end use of item.

6. When the NSN 5985-00-615-2449 was assigned to the Federal Catalog?

   It was assigned 51 years ago, on Wed, Feb 12, 1975