NATO Stock Number
5990-00-482-7927
Sold in multiples of
1 EA
DEMIL
DEMIL/MLI
Body Material
Steel, corrosion resisting
Body Style
Standard round c
Shoulder Diameter
Between 1.5615 inches and 1.5620 inches
Pilot Diameter
Between 0.9370 inches and 0.9375 inches
Overall Length
3.0600 inches
Flange Diameter
Between 1.7450 inches and 1.7500 inches
Flange Thickness
0.0930 inches
Undercut Diameter
1.6250 inches
Undercut Width
0.0780 inches
Shaft Diameter
0.1870 inches single shaft and 0.1872 inches single shaft
Shaft Length
0.5400 inches single shaft
Maximum Tempurature Rise
20.0 degrees celsius
Body Size
18
Rotor Input Voltage Rating In Volts
115.0
Frequency In Hertz
400.0
Rotor Input Current Rating
110.0 milliamperes
Rotor Input Electrical Power Rating
900.0 milliwatts
Zro Impedance Magnitude In Ohms
Between 1045.00 and 1400.00
Zro Impedance Angle In Deg
Between 84.00 and 87.50
Zss Impedance Magnitude In Ohms
Between 40.00 and 57.00
Zss Impedance Angle In Deg
Between 34.00 and 48.00
Phase Shift Angle In Deg
1.500 input to output
Maximum Fundamental Null Voltage In Millivolts Per Volt
40.00 output
Maximum Total Null Voltage Output In Millivolts Per Volt
60.00
Electrical Error Angular Range In Minutes
-6.0/+6.0
Spline Tooth Quantity
21 single shaft
Actuator Friction Torque At Plus 25 Deg Celsius
0.10 inch-ounces
Alignment Hole Quantity
4
Pilot Length
0.0400 inches
Shoulder Length
0.1320 inches
Mounting Surface To Terminal End Distance
2.5200 inches
Spline Tooth Diametral Pitch
120 single shaft
Shaft Thread Series Designator
Unf single shaft
Shaft Thread Direction
Right-hand single shaft
Shaft Thread Class
2a single shaft
Terminal Location
Rear
Shaft Thread Length
0.2000 inches single shaft
Shaft Type
Spline w/threads single shaft
Alignment Hole Depth
0.1250 inches
Transformation Ratio
0.783 rotor to stator
Alignment Hole Bolt Circle Diameter
1.2500 inches
Shaft Thread Size
0.190 inches single shaft
Test Data Document
49956-c362032 drawing (this is the basic governing drawing, such as a contractor drawing, original equipment manufacturer drawing, etc.; excludes any specification, standard or other document that may be referenced in a basic governing drawing)
Terminal Type And Quantity
5 screw
