NSN 402400

An item designed to suppress undesired (interfering) frequencies and have a minimal effect on the desired frequencies when inserted in an electrical power circuit. Excludes:items which consist of a single capacitor, inductor, resistor, or devices consisting of only two or more circuit elements of the same basic name. Excludes:filter, low pass and suppressor, ignition interference. For items designed to be inserted in a line which is primarily intended to carry high frequency waves modulated with signals, such as antenna lead-in, see filter, band suppression and filter, band pass. See also limiter, electrical noise.

2.0 amperes resistive load dc at sea level contact load current rating, 1.0 amperes resistive load ac at sea level contact load current rating, breaks before makes each section rear contact switching action, 110.0 ac at sea level contact voltage rating in volts, 28.0 dc at sea level contact voltage rating in volts.

NSN 5930-01-021-1113 Datasheet

(NSN) National Stock Number

5930-01-021-1113

(FSG) Federal Supply Group

59 - Electrical and Electronic Equipment Components

(FSC) Federal Supply Classification

5930 - Switches

(NIIN) National Item Identification Number

01-021-1113

Requires Demilitarization

Yes

(INC) Item Name Code

02134

Date

Sun, May 9, 1976

Schedule B Code

8536509020

Contact Load Current Rating

1.0 amperes resistive load ac at sea level

Contact Load Current Rating

2.0 amperes resistive load dc at sea level

Contact Switching Action

breaks before makes each section rear

Contact Voltage Rating In Volts

110.0 ac at sea level

Contact Voltage Rating In Volts

28.0 dc at sea level

First Flat Length

0.365 inches minimum and 0.385 inches maximum single actuator

Flat Height

0.214 inches minimum and 0.218 inches maximum single actuator

Individual Section Quantity

5

Mounting Method

threaded bushing with panel seal single mounting facility

Nominal Thread Size

0.375 inches single mounting facility

Nonturn Device Radius

0.531 inches nominal at 4:30 oclock

Nonturn Device Type

tab at 4:30 oclock

Operating Temp Range

-65.0 to 85.0 celsius

Overall Height

1.516 inches minimum and 1.546 inches maximum

Overall Length

3.908 inches maximum

Overall Width

1.296 inches minimum and 1.328 inches maximum

Pole Quantity

3 each section rear

Shaft Diameter

0.247 inches minimum and 0.250 inches maximum single actuator

Shaft Flat/Slot Angular Location

120.0 degrees from nonturn device single actuator

Shaft Type

round, flatted single actuator

Shaft Length

0.828 inches minimum and 0.858 inches maximum single actuator

Style Designator

circular wafer, bushing mount

Switch Actuator Indexing Position Quantity

2 single actuator

Switch Actuator Positioning Increment

60.0 degrees single actuator

Switch Actuator Stop Device Type

fixed stop single actuator

Switch Actuator Stop Device Type

unable to decode

Switch Contact Basic Design

nonpile-up symmetrical

Terminal Type

tab, solder lug

Test Data Document

"81349-mil-s-3786 specification (includes engineering type bulletins, brochures,etc., that reflect specification type data in specification format; excludes commercial catalogs, industry directories, and similar trade publications, reflecting general type data on certain environmental and performance requirements and test conditions that are shown as "typical", "average", "nominal", etc.)."

Thread Length

0.370 inches minimum and 0.380 inches maximum single mounting facility

Thread Series Designator

unef single mounting facility

Throw Quantity

2 each section rear

Identification

Demilitarization Code

A - Items subject to the export administration regulations (ear) in parts 730-774 of title 15, code of federal regulations (cfr) (ccli or ear99) and determined by dod to present a low risk when released out of dod control. No demil, mut, or end use certificate is required. May require an export licensefrom doc.

Precious Metals Indicator

A - Item does not contain precious metal.

Hazardous Metals Indicator

P - Indicates there is no information in the hmirs. The nsn is in a fsc in table ii of fed std 313 and a msds may be required by the user. The requirement for a msds is dependent on a hazard determination of the supplier or the intended end use of item.

Pseudo Item Name Code

0002134

Cross Reference

CAGE Codes

12909

Cardion Inc

U.s./canadian manufacturers

20284

Aimtron Systems, Llc

Non-manufacturers

76854

Electro Switch Corp. Dba Oak Grisgsby Div Electroswitch

U.s./canadian manufacturers

Freight Information

Air Commodity

HZ -

Air Dimension

A - Shipment is not a consolidation and does not exceed 84 inches in any dimension.

National Motor Freight Class Rating

M - 85.0

Special Handling

9 - Other or no special handling required (sh)

Type of Cargo

Z - No special type of cargo code applicable

Uniform Freight Classification Item Number

34430

Water Commodity

72D - Communications/electronics, other than sigint/ew or comsec repair parts and components

National Motor Freight Classification Item Number

061360

Schedule B & Trade

Schedule B

8536-50-9020

Description

switches, rotary, rated at not over 5 a, for a voltage not exceeding 1,000 v

End Use

20005 - Electric apparatus

Unit of Quantity

NO

USDA

Yes

(SITC) Standard International Trade Classification

77255

(NAICS) North American Industrial Classification System

335931

Questions & Answers

1. What is the FSCG of the NSN 5930-01-021-1113?

   The FSCG of the NSN 5930-01-021-1113 is 5930

2. Does the NSN 5930-01-021-1113 have a Schedule B code assigned?

   Yes, the Schedule B code is 8536509020

3. Does NSN 5930-01-021-1113 require demilitarization?

   Items subject to the export administration regulations (ear) in parts 730-774 of title 15, code of federal regulations (cfr) (ccli or ear99) and determined by dod to present a low risk when released out of dod control. No demil, mut, or end use certificate is required. May require an export licensefrom doc.

4. Does NSN 5930-01-021-1113 contain precious materials?

   Item does not contain precious metal.

5. Does NSN 5930-01-021-1113 contain hazardous materials?

   Indicates there is no information in the hmirs. The nsn is in a fsc in table ii of fed std 313 and a msds may be required by the user. The requirement for a msds is dependent on a hazard determination of the supplier or the intended end use of item.

6. When the NSN 5930-01-021-1113 was assigned to the Federal Catalog?

   It was assigned 50 years ago, on Sun, May 9, 1976