NATO Stock Number
5905-00-061-2154
Sold in multiples of
1 EA
DEMIL
NO
Section Quantity
1
Body Style
Cylindrical servo mounted
Pilot Diameter
0.96880 inches
Pilot Length
0.06200 inches
Overall Length
1.462 inches
Undercut Diameter
1.000 inches
Undercut Width
0.05700 inches
Body Diameter
1.000 inches
Shaft Diameter
0.1246 inches
Shaft Length
0.620 inches
Body Length
0.812 inches
Overall Diameter
1.362 inches
Mounting Lip Diameter
1.09500 inches
Mounting Lip Depth
0.06200 inches
Shaft Style
Round, slotted
Shaft Bearing Type
Ball
Actuator Type
Single shaft
Effective Electrical Rotation In Deg Angular Rotation
260.0
Maximum Starting Torque
1.00 inch-ounces
Shaft End Play
0.00200 inches
Shaft Runout
0.001 inches
Lateral Runout
0.002 inches
Pilot Diameter Runout
0.00100 inches
Shaft Radial Play
0.0007 inches
Mechanical Backlash In Deg Angular Rotation
0.15
Terminal Location
Radially positioned over less than half the circumference
Mounting Method
Clamp ring
Features Provided
Nonmetallic shaft
Electrical Resistance Per Section
20.000 kilohms single section
Rotary Actuator Travel In Angular Deg
360.0
Ambient Tempurature In Deg Celsius Per Section At Zero Percent Rated Power
125.0 single section
Tempurature Coefficient Of Resistance Per Section In Ppm Per Deg Celsius
-500.0/+500.0 single section
Tempurature Coefficient Of Resistance Per Section In Ppm Per Deg Celsius
-500.0 to 500.0 single section
Power Dissipation Rating Per Section In Watts
0.125 free air single section
Resistance Tolerance Per Section In Percent
-10.0/+10.0 single section
Resistance Tolerance Per Section In Percent
-10.0 to 10.0 single section
Actuator Travel Control Feature
Continuous motion
Ambient Tempurature In Deg Celsius Per Section At Full Rated Power
115.0 single section
Standard Taper Curve Per Section
A single section
Test Data Document
89954-539d763 drawing (this is the basic governing drawing, such as a contractor drawing, original equipment manufacturer drawing, etc.; excludes any specification, standard or other document that may be referenced in a basic governing drawing)